Drainage, Cleaning And Storage - mspa BAIKAL Manuel D'utilisation

DRAINAGE, CLEANING AND STORAGE

Spa Drainage
1. Turn off all the buttons (heater, filter and bubble) on the wired controller.
2. Connect the drain valve adapter to a garden hose and point the other end of the garden hose to a suitable
draining area with local environmental regulations. (Fig.1)
3. Remove the drain valve cap from the outside of the spa tub and attach the drain valve adapter with the
garden hose to the drain valve. (Fig.2)
4. From the inside of the spa tub, open the drain valve cap, water will start flowing out through the garden
hose. (Fig.3)
5. When the water stops draining, lift the spa tub wall from the opposite to the drain, leading any remaining
water to the drain and empty the spa water completely. (Fig.4)
BUBBLE
minutes to blow out all the remaining water. (Fig.5)
7. When the water stops draining, use a clean towel to wipe up any remaining water and moisture on the spa
1
garden hose
4
Spa Tub Cleaning
If dirt is visible in the water or the water becomes cloudy and proper water chemistry does not clear it up,
change the water and clean the spa tub.
filter cartridge. Use a sponge and mild soap solution to wipe away any soil or stains on the inside of the spa
wall. Rinse thoroughly before refilling with clean water.
IMPROTANT: Do not use steel wool, hard brushes or abrasive cleaners.
Spa Tub and Air Bladder Repair
2
17
5
JET
21
3
15
minutes