First Use And Set-Up Preparation - mspa Alpine Manuel Du Propriétaire

REF. NO.
A
(Square shaped spa comes with a ground mat with the cover)
B
C
D
Digital lock (for D-NE02, D-SC04/06, D-AU04/06, D-CA04/06, D-ST04)
E
F
G
H
I
J
Buckle spa cover and ground mat set (For D-AL04/06, D-TE06)
K
NOTE: When ordering parts, be sure to quote the model number and part numbers.

FIRST USE AND SET-UP PREPARATION

Site preparation and requirements
The spa can be installed indoor and outdoor around 10 minutes by at least one person. For household use
only.
The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the
maximum load of the filled spa with listed maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water.
Provide adequate drainage system around the spa to deal with overflow water and splashes.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
Additional requirements for indoor installation
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet or
any other material that could be damaged by the moisture.
Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
Spa tub
Wired controller
Filter cartridge
Spa drain valve adaptor
Repair kit
Wrench
Wicker side bar (Only for Nest D-NE02)
Instruction DVD
10
QTY.
1
1
1
1
1
1
1
1
1
1
1