First Use And Set-Up Preparation - mspa MONO C-MO04 Manuel D'utilisation

REF. NO.
A
B
C
D JOMBO 23.5" high pressure pump, inflation hose, pressure gauge, seal ring
E
F
G
H
I
J
K
NOTE: When ordering parts, be sure to quote the model number and part numbers.

FIRST USE AND SET-UP PREPARATION

Site preparation and requirements
● The spa can be installed indoor and outdoor around 15 minutes by at least one person. For household use
only. For household use only.
● The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the
maximum load of the filled spa with listed maximum occupants.
● Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water.
● Provide adequate drainage system around the spa to deal with overflow water and splashes.
● Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
Additional requirements for indoor installation
● Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
● Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of
any other material that could damaged by the moisture.
● Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
PARTS DESCRIPTION
SPA cover with buckle and inflatable bladder
Spa tub
Control box , wired controller and U-shape cover
Heat preservation foam mat
Filter cartridge
Spa drain valve adaptor
Wrench for filter
Wrench for valve
Repair kit
Instruction DVD
10
QTY.
1
1
1
1
9
2
1
1
1
1
1