Stihl MS 200 T Notice D'emploi page 13

Mounting the guide bar
7
8
N Turn the screw (7)
counterclockwise until the tensioner
slide (8) butts against left end of
housing slot.
9
10
N Fit the guide bar over the stud (9)
and engage the peg of the tensioner
slide in the locating hole (10).
Fitting the chain
Wear work gloves to protect your
hands from the sharp cutters.
MS 200 T
All manuals and user guides at all-guides.com
11
N Fit chain around the sprocket (11)
and over the guide bar – cutting
edges on top of bar must point to
bar nose.
7
N Turn the tensioning screw (7)
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
N Refit the sprocket cover –
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud fingertight.
N Go to chapter on "Tensioning the
Saw Chain"
English
11