1Step Extraction Kit; Elevation Kit - ZUMEX Versatile Pro Manuel De L'utilisateur

1Step Extraction Kit

This device allows for easy insertion and removal of the pressing units and peel
ejectors in just one step (Fig. 15).
Before installation remember to insert the Blade holder (9).
To install, line up the pressing units with the shafts and adjust their position
while sliding them in. Use the central knob to attach the device to the machine.
Note: To remove simply reverse the process.
Assembly of the 1Step Kit (Fig. 16)
a) Place the rear holder (22) on a surface. The metal ejector holders should
be face down.
b) Match up the lower and upper pressing units (4 and 5). Line up the circular
bases of the pressing units with the holes on the holder. Note that the faces
of the pressing units are different.
Ensure to mount them as shown in the figure.
d) Line up the protruding cones of the pressing units with the four circular
bushes on the front holder (21).
e) Join both holders with the plastic securing knob (15).
c) Turn the 1step kit 180º and line up the ejectors (7 and 12) with the ejector
holders, inserting the extractor blade into the seal of the lower pressing unit.
Ensure that both holders are inside the ejector channel as shown in image 4.
Disassembly of the 1Step Kit (Fig. 16)
c) From the position shown in image 4, pull the ejectors (7 and 12) sideways
to remove them from the metal holders.
a) Turn the kit 180º and unscrew the plastic securing knob (15), which is
located behind the pressing units and holds both metal holders (21 and 22).
b) Carefully pull the front holder (21).
c) Separate the lower pressing unit (4) and the upper pressing unit (5).
Note: To clean the unit, refer to the Cleaning section.

Elevation Kit

This Zumex machine has an Elevation Kit to make it easier to clean the surface
where it is located. Elevation Kit ref. 05230* is not included in this model, it is
available in the machine accessory catalogue.
This Kit must be mounted according to the following instructions:
Components
Installation
The machine comes prepared for this Kit to be simply and quickly installed.
1
Place machine in assembly position.
Carefully place the machine on one of its sides, previously protecting this
area to prevent damage to the machine. This operation must be carried
out between two people, so that the base of the machine is in view,
facilitating the work process.
Legs 4
Adhesive felt disc 4
Screw-in stud 4
EN
31