Configuration - ZUMEX Versatile Pro Manuel De L'utilisateur

As a general rule, to operate within the menu, we can regard the "ON" button
as accept and "OFF" as cancel.
Operating Modes with Zumex Essential Pro
Zumex Essential Pro can work in two operating modes:
Autostart: The machine detects the oranges in the feeder tube and starts up
as the oranges pass by.
Self-service: The machine starts up by activating the self-service faucet either
by pressing the faucet or by activating the switch lever; in order to be able to
operate with this switch lever see Fig. 12A and 12B. In this mode you can also
work continuously by turning the faucet block 90º (Fig. 13).
Selection of operating mode:
1
Press the MENU key for a few seconds to enter the programming mode.
2
Select the WORKING MODE option by positioning the cursors
and pressing ON to confirm your selection.
3
Select the desired working mode, Autostart or Self-Service using the cursors
and press on to confirm your selection. Press OFF several times until you
exit MENU.
Operating Modes with Zumex Versatile Pro
Zumex Versatile can operate in two working modes:
Professional: You can programme the no. of oranges to be squeezed in each
cycle using the cursors , and you can programme up to 20 oranges in each
cycle or select the 'c' option to squeeze continuously. The squeezing will start by
pressing 'ON' and it will end after ceasing to squeeze the no. of oranges pro-
grammed or if you press 'OFF'.
Self-service: The machine starts up by activating the self-service faucet either
by pressing the faucet or activating the switch lever. You can also work conti-
nuously in this mode by turning the faucet block 90º (Fig. 13).
Selection of the operating mode:
1 Press the MENU key for a few seconds to enter the menu.
2
Select the WORKING MODE option by positioning the cursors
pressing ON to confirm your selection.
3
Select the desired working mode, Professional or Self-Service using the cursors
and pressing ON to confirm your selection. Press OFF several times until
you exit MENU.

Configuration

Your Zumex juicer allows you to adjust the parameters according to your prefe-
rences. All adjustments are made at MENU > CONFIGURATION. Press the MENU
key for a few seconds to enter the menu and select CONFIGURATION, press ON
to confirm your selection.
over it
Lighting: Changes the screen brightness level.
On the CONFIGURATION menu select LIGHTING and press ON to confirm your
selection. Adjust the brightness level using the cursors
firm by pressing ON. The changes will be memorised.
Language: Changes the juicer menu language.
On the CONFIGURATION menu select LANGUAGE and press ON to confirm
your selection. Select the language desired using the cursors
ted confirm by pressing ON. The changes will be memorised.
Offset: Depending on the type of fruit to be squeezed, the value can be adjus-
ted for its optimum counting.
Select OFFSET and press the ON key and you will be immediately asked
for your PIN. If you don't have one, consult your Technical Service. Then you
configure the desired number using the cursors
been concluded, press ON to save the changes. This operation must only be
carried out under the supervision of an authorised Technical Service.
Note: Remember that if you press OFF, you will cancel any
changes made before and you will return to the previous menu.
EN
and
. Once adjusted, con-
. Once selec-
. Once the adjustment has
21