1Step Extraction Kit - ZUMEX Essential Manuel De L'utilisateur

• The plastic parts of the squeezing system are suitable for cleaning in a
dishwasher.
• We do not recommend cleaning the cover and the juice container using the
dishwasher. Follow this recommendation to increase their durability. To clean
both parts, use a soft cloth soaked in water and Citric Active or food-grade
soap. Under no circumstances should you use abrasive or anti-lime products.
• The juice tap and tray must be separated for their correct cleaning, preventing
dirt from accumulating between both. The tap may be cleaned in the dishwasher.
• When cleaning the squeezing and cover area you should use a soft cloth
dipped in water and washing-up liquid. Then rinse thoroughly in clean water so
no soap remains.
• Once the cleaning process has finished, you must assemble all the elements
in reverse order to their disassembly. Make sure that all the parts have been
correctly assembled and secured.
• Remember that each peel ejector (Fig. 8) only fits on one side and so they are
not interchangeable. When you place them make sure that you insert the peel
ejector paddle right down to the end of the lower pressing unit.
• In order to avoid the accumulation of wax it is important to clean the fruit
feeder frequently of Zumex Versatile Pro models.
• On models with a base stand clean the hopper and the inside of the stand,
making sure to eliminate any peel or pulp remains.

1Step Extraction Kit

This device allows for easy insertion and removal of the pressing units and peel
ejectors in just one step (Fig. 15).
Before installation remember to insert the Blade holder (9).
To install, line up the pressing units with the shafts and adjust their position
while sliding them in. Use the central knob to attach the device to the machine.
Note: To remove simply reverse the process.
Assembly of the 1Step Kit (Fig. 16)
a) Place the rear holder (22) on a surface. The metal ejector holders should
be face down.
b) Match up the lower and upper pressing units (4 and 5). Line up the circular
bases of the pressing units with the holes on the holder. Note that the faces
of the pressing units are different.
Ensure to mount them as shown in the figure.
d) Line up the protruding cones of the pressing units with the four circular
bushes on the front holder (21).
e) Join both holders with the plastic securing knob (15).
c) Turn the 1step kit 180º and line up the ejectors (7 and 12) with the ejector
holders, inserting the extractor blade into the seal of the lower pressing unit.
Ensure that both holders are inside the ejector channel as shown in image 4.
Disassembly of the 1Step Kit (Fig. 16)
c) From the position shown in image 4, pull the ejectors (7 and 12) sideways
to remove them from the metal holders.
a) Turn the kit 180º and unscrew the plastic securing knob (15), which is
located behind the pressing units and holds both metal holders (21 and 22).
b) Carefully pull the front holder (21).
c) Separate the lower pressing unit (4) and the upper pressing unit (5).
Note: To clean the unit, refer to the Cleaning section.
EN
35