Operating The Cordless Compressor Pak 20-Li A1; Display Indicator; Setting The Pressure; Initial Operation - Parkside PALP 20-Li A1 Traduction Des Instructions D'origine

Operating the cordless
compressor PAK 20-Li A1
This appliance is not designed for continuous
operation. The appliance may be used for a maxi-
mum of 10 minutes continuous operation. If the
appliance overheats, remove the battery pack
Allow the appliance to cool down completely and
then try using it again.

Display indicator

♦ Press the ON/OFF switch
or press the ON/OFF switch
the display indicator
♦ The last set pressure is displayed for 2 seconds.
♦ After two seconds, the current pressure of the
connected item is shown.
NOTE
► If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0".
♦ If the display indicator
can switch between "bar" and "psi" by pressing
the ON/OFF button
♦ To switch off the display indicator
ON/OFF button
NOTE
► The compressor will not work if the display
indicator is switched off.
PAK 20-Li A1 / PALP 20-Li A1
on the display
to switch on
.
is switched on, you
.
, press the
for 3 seconds.

Setting the pressure

♦ Hold down the "+"
display flashes.
♦ Press the "+"
desired pressure.
.
♦ Once you see the desired pressure on the
display indicator
for about 3 seconds.
The desired pressure is now set.
NOTE
► The display indicator
pressor) switches off after around three
minutes of inactivity.
TIP
► If you press and hold the "+"
button, the pressure changes quickly.

Initial operation

♦ Loosen the cap nut
pletely!), twist in the compressed air hose
threaded connection
cap nut .
♦ Select the desired pressure.
♦ Insert one of the supplied adapters ( ,
, , ) tightly onto the compressed air hose
adapter .
♦ Connect the adapter
to the object to be inflated.
♦ Press the ON/OFF switch
♦ The compressor switches off automatically when
you reach the preset pressure.
♦ Pull the adapter
the now inflated item.
or "–" button until the
or "–" button to set the
, do not press any button
(and thus the com-
or "–"
(do not unscrew it com-
22a
and retighten the
, , , ,
.
, , , , or
GB │ IE │
, ,
or
out of
23 ■