Operating the cordless
compressor PAK 16 A1
This appliance is not designed for continuous
operation. The appliance may be used for a maxi-
mum of 10 minutes continuous operation. If the
appliance overheats, remove the battery pack
Allow the appliance to cool down completely and
then try using it again.
Display indicator
♦
Press the ON/OFF switch
or press the ON/OFF switch
the display indicator
♦
The last set pressure is displayed for 2 seconds.
♦
After two seconds, the current pressure of the
connected item is shown.
NOTE
►
If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0".
♦
If the display indicator
can switch between "bar" and "psi" by pressing
the ON/OFF button
♦
To switch off the display indicator
ON/OFF button
NOTE
►
The compressor will not work if the display
indicator
is switched off.
PAK 16 A1 / PALP 16 A1
on the display
to switch on
.
is switched on, you
.
, press the
for 3 seconds.
Setting the pressure
♦
Hold down the "+"
display flashes.
♦
Press the "+"
desired pressure.
.
♦
Once you see the desired pressure on the
display indicator
for about 3 seconds.
The desired pressure is now set.
NOTE
►
The display indicator
pressor) switches off after around three
minutes of inactivity.
TIP
►
If you press and hold the "+"
button, the pressure changes quickly.
Initial operation
♦
Loosen the cap nut
pletely!), twist in the compressed air hose
threaded connection
cap nut
.
♦
Select the desired pressure.
♦
Screw one of the supplied adapters ( ,
,
, ) tightly onto the compressed air hose
adapter
.
♦
Connect the adapter
to the object to be inflated.
♦
Press the ON/OFF switch
♦
The compressor switches off automatically when
you reach the preset pressure.
♦
Pull the adapter
the now inflated item.
or "–"
button until the
or "–"
button to set the
, do not press any button
(and thus the com-
or "–"
(do not unscrew it com-
and retighten the
22a
,
,
,
,
.
,
,
,
,
or
GB │ IE │ NI
,
,
or
out of
│
9
■