American Standard Studio ActiVate Right Height 2795.119 Mode D'emploi page 4

Masquer les pouces Voir aussi pour Studio ActiVate Right Height 2795.119:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING: Overtightening of water supply line nuts could result in breakage and potential flooding. If the
!
connection leaks after hand tightening, replace the supply line. Do not use any type of sealant on the water
supply connection. Use of plumber's putty, pipe dope, or any other type of sealant will void the warranty.
9
ACTUATOR FACE
POWER ICON
AA BATTERY PACK
TO INSTALL BATTERIES
!
(4) AA Batteries ONLY
(DO NOT USE 9 VOLT)
TO OPERATE TOILET
TO OPERATE ON/OFF FEATURE
On/Off feature puts the sensor into an off mode for 10
minutes, allowing time to clean in the bathroom area
without constantly flushing the touchless toilet.
MANUAL FLUSH BUTTON
FILL VALVE
ACTUATOR
AIR HOSE
OPERATIONAL GUIDE
Step 1) Lift open rubber battery housing cover, remove battery tray and install 4 alkaline AA
batteries into the battery tray.
Step 2) Insert battery tray back into the battery housing and connect sensor plug to battery tray.
Sensor will flash red once followed by 3 consecutive blue flashes.
Step 3) Route wires through slot in battery housing and close battery housing cover making sure it is
secure to prevent corrosion.
*
Step 1) Turn on water supply. Adjust water level to water level line indicated on the back of the tank by
turning Water Level Adjustment Knob on fill valve to move float cup up or down. Turning
knob clockwise raises water level. Turning knob counterclockwise lowers water level.
It is critical that water be filled exactly to specified water level for optimum performance.
Step 2) To flush toilet, swipe hand within 3 inches of activation sensor on side of toilet. Sensor will flash
blue twice.
Step 1) Feature is activated by touching the Power Icon for 3-6 seconds. Sensor will flash blue twice
and then constantly flash red while in this mode.
Step 2) Exit off mode by touching the Power Icon for 3-6 seconds. Sensor will flash blue 4 times.
WATER LEVEL ADJUSTMENT KNOB*
*See Step 1 of "TO OPERATE TOILET" of
"OPERATIONAL GUIDE" below.
- 4 -
HOSE LOCK
COLLARS
FLUSH VALVE TOWER
Adjust water level to the water level
line indicated on the back of the tank.
7302 165 - 100 Rev. A

Publicité

Table des Matières
loading

Table des Matières