INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
BABY DEVORO - 1.28 GPF TWO-PIECE TOILET
Model 2315
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Hacksaw
Wax Ring/Gasket
1
REMOVE OLD TOILET
a. Close toilet supply valve and flush tank
completely. Towel or sponge remaining
water from tank and bowl.
b. Disconnect and remove supply line.
NOTE: If replacing valve, first shut off main
water supply!
c. Remove old mounting hardware, remove
toilet and plug floor waste opening to
prevent escaping sewer gases.
d. Remove closet bolts from flange and clean
away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean
and level before new toilet is installed!
3
CLOSET
FLANGE
A
CLOSET
BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange
channel, turn 90 ° , and slide
into place 6" (152mm) apart
and parallel to wall.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 11
All manuals and user guides at all-guides.com
Adjustable Wrench
Flexible Supply Tube
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed below:
FINISHED WALL
10"
(254mm)
4
SEALANT
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent
damage), and install wax ring evenly
around waste flange (horn), with tapered
end of ring facing toilet. Apply a thin bead
of sealant around toilet base.
Sealant
Closet Bolts
FINISHED
FLOOR
5
WAX RING
POSITION TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet flange
so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of washers
marked "THIS SIDE UP" must face up!
Tape Measure
Carpenters Level
SUPPLY
AS
REQ'D.
NUT
TAPERED
WASHER
CLOSET
BOLT
FLANGE
7301860-100