Monitor Unit Battery Installation; Charging And Powering The Monitor Unit - Luvion GRAND ELITE 2 Manuel D'instructions

GRAND ELITE 2
12

3.3 MONITOR UNIT BATTERY INSTALLATION

1. Insert the Rechargeable Li-ion Battery into the Battery Compartment as shown above.
2. Insert the wire tab of the Rechargeable Li-ion Battery into the contact slots as shown
above.
3. Replace the battery cover over the compartment.

3.4 CHARGING AND POWERING THE MONITOR UNIT

For best results, charge the Monitor Unit before use. After the initial charge, recharge
EN
normally as required. The Monitor Unit can be operated normally with power adapter
plugged into the unit with the battery installed.
1. Fit the USB Power Cable into the USB outlet of the USB Output Adapter. Plug the
USB Output Adapter into the electrical outlet. Connect the small end of USB Power
Cable to the USB DC Jack of the Monitor Unit.
2. Press and hold the
the Monitor Unit. The POWER LED indicator will illuminate green to indicate the unit
is ON.
3. Once both the Camera and Monitor Units are switched on, the display on the Moni-
tor Unit will show the video captured by the Camera Unit.
4. If there is no connection or you are out of range, the video display will go o and the
screen WARNING: Out of signal coverage will be shown on the LCD display. The unit
will also beep every 10 seconds. Move the Monitor Unit closer to the Camera Unit
until the link is re-established.
5. Press and hold the
nishes scrolling, to tum OFF the Monitor Unit .
Premium Babymonitor
POWER ON/OFF/SLEEP button for 2 seconds to tum ON
POWER ON/OFF/SLEEP button, until the progress bar