Luvion GRAND ELITE 2 Manuel D'instructions page 22

GRAND ELITE 2
22
The picture playback
is not smooth
(choppy video with
low frame rate)
Camera Unit
power LED changes
brightness
Noise
(static, beeping)
Noise
interference on
EN EN
your Monitor
Unit
The rechargeable
battery will not
charge or
no charge light
Pairing failed
Premium Babymonitor
• Try moving the Camera Unit closer to the Monitor Unit.
• Remove obstructions between the Camera and Monitor
Unit.
• Adjust the monitor antenna to vertical position.
• Use of other 2.4GHz products, such as wireless networks
(WiFi routers), Bluetooth systems, or microwave ovens,
may cause interference with this product. Keep Camera
and Monitor Unit at least 5ft (1.5m) away from these
items, or tum them o if they appear to cause interfer-
ence.
• This is normal. The Power LED indicator is set to dim when
in the dark, and brighten when ambient light is detected.
• Battery power may be too low; recharge or replace
battery.
• Possible alarm ring alert.
• Possible out of signal alert.
• Volume may be set too high on the Monitor Unit. Lower
volume.
• The Camera and Monitor Units may be too close. Move
them further apart.
• The Camera Unit may be too far away and out of range.
Move the Camera Unit closer to the Monitor Unit.
• Make sure the Camera and Monitor Units are placed away
from other electrical equipment, such as a television,
computer or cordless/mobile telephone.
• The USB Output Adapter may not be properly connected.
• Battery pack may not be properly connected inside the
battery compartment. Reconnect the wire tab of battery.
• Try using the other USB Power Cable included.
• There may be no power from the USB outlet. Switch to
another electrical outlet (if using USB Output Adapter) or
another USB power source (if using computer/laptop USB
power).
• Make sure that the Power Adapter is connected to the
Camera Unit.
• Con rm that the Camera Unit is turned ON (Power LED
indicator shows green light).
• Try pairing to another CAM channel.