Norcold Polar 10 Serie Manuel D'installation page 11

Masquer les pouces Voir aussi pour Polar 10 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Change the position of the cabinet hinges and the strike plate and remove the control housing.
(See Art 02631)
- Remove and save the screws from the strike plate and hole cover.
- Remove center hinge [363] and screws.
- Flip center hinge [363a] over and reinstall on other side of cabinet.
- Remove and save the screws from the upper cabinet hinge [66].
- Put the hinge on the other side of the refrigerator [66a].
- Attach the hinge with screws.
- Tilt the cabinet to the side to allow access to the bottom hinge screws.
- Remove and save the screws from the lower cabinet hinge [67].
- Put the hinges on the other side of the refrigerator [67a].
- Attach the hinge with screws.
- Install strike plate and hole cover with screws on the other side of control.
- Rotate the control housing 180° and put it on the opposite side of the controls (See Art 02636 & Art
02635).
- Snap the control housing to the refrigerator.
3. Change the position of the door handles (See Art 02630):
- Remove the screws, [41] door handle, [70] latch pin [363] and spring [362] from each door.
- Put the lower door handle on the upper door and the upper door handle on the lower door.
- Attach each door handle with the screws.
4. Reinstall the doors (See Art 02683):
- Turn the lower hinge pins into the lower cabinet hinges.
To prevent damage to the threads of the hinge pins, turn the hinge pins by hand until tight and then tighten with a
NOTICE
screwdriver.
Apply Loctite removable thread locker (blue) to the threads of the hinge screws before assembly to prevent
!
CAUTION
loosening during use. Do not allow Loctite to contact any of the plastic surfaces of the refrigerator because
it can damage those surfaces.
- Put each door down onto the lower hinge pin.
- Align the holes in the upper hinges and hold in this position.
- Turn the upper hinge pin into the hinges of each door.
- Tighten the hinge pins.
- Put the storage bins in the doors.
Art 02636
66
66a
363
363a
67
Art 02631
67a
41
363
362
Art 02630
Art 02635
Installation Manual 11
70

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Polar 10 n10lxPolar 10 na10lxPolar n10lxPolar na10lx

Table des Matières