Working And Use - lamber 050F Instructions D'emploi

First Section - FOR THE USER

WORKING AND USE

The dishwashing machine 050F can wash up to 500 dishes every hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water.
The objects to be washed should be correctly arranged for a good washing-up result.
We suggest to descale glasses, from time to time, in order to remove calcareous and/or starchy sediments
by soaking them in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following: Dishes and cups: preference must be given to
china or non-porous pottery articles, with smooth surface. Glasses: choose a glass suitable to be washed
in dish-washing machines. Surfaces must be smooth and bottoms as flat as possible.
OPERATION BEFORE WORKING
B
EFORE STARTING THE WORKING OPERATION MAKE
:
SURE THAT
- the cock is open;
- the filter and
their housings;
- the wash arm and the rinse arm are free to
pivot;
- the rinse aid dispenser containers are
loaded.
T :
HEN PROCEED
A
- Open the door and put into the tank,
possibly over the pump filter, about 54 gr.
of non-lathering detergent in powder.
Every 10 cycles add about 40 gr. of detergent.
If the machine is provided with an automatic
dosing device, control that the detergent is in its
container.
B
- Place the dishes in the basket minding to
previously remove all solid waste and fat.
Do not overload baskets, dishes must not be
placed one upon the other, water must have the
way to run on each part of the same.
C
- Turn the machine on by wall switch and
push the switch "A" on the ON position.
The green lamp "G" lights up and the machine
loads automatically (with closed Door). When
the level has been reached, the lamp "E" lights
up .
D
- Put the basket into the machine.
Close the door and push the button "B".
the overflow are in
The green lamp "F" will light up and the cycle
will start for 2 minutes, including, besides the
washing, a five seconds stop and the rinsing of
fifteen seconds with clean water at 85°-90°C will
start. At the end of the cycle the lamp "F" will
go out.
Note: The rinse
temperature of the water is 90°C.
Bear in mind that the opening of the door
interrupts the cycle and therefore the machine
at any moment. Pratically, the opening of the
tank works as an emergency device.
E
- Take the basket away and repeat the
operation "D".
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Halos
might be caused by an insufficient rinsing: in
this case, check that the rinsing jets are clean
and there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the positions of the objects in the rack are
correct.
ENGLISH
starts only when the