Honda EM50is Manuel De L'utilisateur page 72

4.Pass the remote control cable through the supplied wire grommet and
fit the grommet into the maintenance cover knockout.
5.Plug the remote control cable into the 6-pin connector.
6.Install the maintenance cover and tighten the cover screw.
REMOTE CONTROL CABLE
REMOTE CONTROL CABLE
REMOTE CONTROL BOX
7.To avoid accidentally unplugging the remote control cable, secure the
cable to the generator frame with a cable tie as shown.
CABLE TIE
• Never operate the generator without the maintenance cover in place,
as poor engine and generator performance will result.
• When the remote control is not being used, replace it with the plug
on the connector.
70
MAINTENANCE COVER
PLUG
6-PIN CONNECTOR
WIRE GROMMET