Delivery Content - Reely SKY Agusta Notice D'emploi



5. Delivery content

• Pre-assembled helicopter
• Transmitter
• Operating instructions
The spare parts list is located on our Internet page www.conrad.com in the download section to the respective
product.
You can also order the spare parts list by phone. For the contact data, please refer to the top of these
instructions in the chapter "Introduction".
For transport reasons, the tail fins are not mounted on the fuselage and must be glued in with 5-minute
epoxy resin. The manufacturer only lacquers the visible parts of the aircraft. Unlacquered spots or spray
mist on invisible parts of the model may stay as they are or can be lacquered according to taste. However,
the matching paint is not part of the delivery and must be purchased separately.
The following components which are not included in the contents of the plane model are required for the assembly and
operation:
Assembly:
Soldering iron, screwdriver, screw retention lacquer, 5-minute epoxy resin adhesive, poss. thixotropic agent (micro
balloon or cotton flakes) to thicken the resin, Velcro fastener and double-sided adhesive tape.
Attention!
Observe the security notes of the respective manufacturer when using glues and perform gluing work in
well aired rooms only.
Operation:
Operation of the remote control transmitter requires 8 batteries/rechargeable batteries type mignon, a 3-cell LiPo flight
battery with approx. 2500 mAh and a discharge rate of 25 C as well as the corresponding plug-type connections for the
rotation speed adjuster and flight battery.
For tried-and-tested accessories, refer to our catalogues or see www.conrad.com.
38