GYS NEOCUT 105 Mode D'emploi page 26

« SETUP » MENU (access via scroll wheel)
CONSUMABLES
AIR TEST
TORCH LENGHT
LOG BOOK
EN FR DE IT...
UNITS
EXIT
COUNTERS
1
ELECTRODE
0 Cycl./
2
TIP
0 Cycl./
RESETS
EXIT
RESETTING THE COUNTERS
To carry out a reset, select the desired line by turning the scroll wheel and press and hold down (a countdown is displayed to
the right of the selected line), at the end of the countdown the selected line is reset to zero.
Releasing the scroll wheel during the countdown cancels the action.
Note: this function is to assist with monitoring the consumables for wear and tear. The user is not obliged to use this function
and even less to reset the counters each time the consumable is changed (the machine does not lock up if the number of
cycles or operating times is too high).
26
NEOCUT 105 / 125
6.0m
5.2
bar
105 A
optimal
6.0m
5.2
bar
105 A
+0.2
.0H
This tool counts the number of cycles and the nozzle and electrode cutting time:
1- Number of cycles and cumulative use time of the electrode
2- Number of cycles and cumulative use time of the nozzle
.0H
3- Meter reset menu
3
4- Go back to the Setup menu
4
1
RESET ELECTRODE
2
RESET TIP
RESET ALL
3
EXIT
4
At the end of the countdown, the following screen will appear:
- the padlock is open (symbolizing that the adjustment is possible)
- the current pressure is displayed (the value corresponds to the value used in
automatic mode)
- A bar-graph with a value gives the trend (the text «optimal» is displayed when
the chosen value corresponds perfectly to the value that would be used in auto-
matic mode).
Example of a pressure setting higher than the optimum value of +0.2bar
To return to automatic setting, press and hold down the scroll wheel: a countdown
will start next to the padlock.
At the end of the countdown, the setting will be in «AUTO» with the padlock
locked.
In order to have a representative count, it is necessary to reset the counter(s) of
the consumable(s) being replaced.
The counter reset menu offers :
1- Zeroing of the electrode counters
2- Zeroing of the nozzle counters
3- Zeroing of all counters
4- Go back to the previous screen
EN