Becker Traffic Pro Instructions De Montage page 20

Installation guide
Press the right rotary knob
The previously entered data is displayed again. f the data entered is cor-
rect select line with data by turning the right rotary knob
press to confirm.
If correction is necessary, select
knob and press to confirm. The values can then be re-entered.
After confirming the tire data or the previously confirmed point
SEL. CALIBRATION
After a short time, the unit switches to the main navigation menu or the
calibration ride is requested.
The unit is now in calibration status 2. Absolute precision
is, however, only achieved as of calibration status 3.
Status of calibration ride (
In the Service Mode, select
knob and press to confirm.
The calibration status (e.g.
(e.g. ) are displayed. After completing calibration, the street on
3D
which you are currently driving is displayed (provided that it is digi-
tised) instead of
WHEEL
Testing the system components (
A test program automatically tests the internal components of the navi-
gation system.
In the Service Mode, select
knob and press to confirm. If
The unit switches back to the Service Mode.
Subject to correction and technical modifications
to confirm the selection.
by turning the right rotary
MODI.Y
, the adjacent display appears.
CALIB RATION RIDE )
using the right rotary
CALIBRATION RIDE
) and the type of positioning
STATUS: 2
and .
REVERSE
)
MODULE TEST
using the right rotary
MODULE TEST
is displayed, press the
OK
and then
1 8 5 / 0 5 5 / 0 1 5 , N E W
MODI.Y
START
CALIBRATION
C A L I B R A T I O N R I
MODULE TEST
STATE: 2 3D_.IX
MAINSTREET
11:38.34E 54:49.14N
CALIBRATION RIDE
M O D U L E T E S T
Nav button.
SENSORS
20
INPUT DONE
Copyright by Becker GmbH, D-76303 Karlsbad