Installation / Removal Of The Traffic Pro - Becker Traffic Pro Instructions De Montage

7. Installation / Removal of the Traffic Pro

• Installation:
A universal mounting for DIN installation slots is integrated into
Traffic Pro. An installation frame or sleeve is not required. The
unit is inserted into the installation slot and secured with the slides
supplied.
To install, complete all electrical connections. Then push the unit
into the installation slot. Subsequently, insert slides into the open-
ings on the front of the unit until the first detent position (Fig. A).
Next lock the radio in by pulling on both slides as shown in Fig. B.
Subsequently, remove the slides.
The installation angle of the unit must not exceed 0° - 35°
(vertical).
• Removal:
To remove the unit, it must first be unlocked. For this purpose,
push in both slides to the second detent position, as shown in Fig-
ure A. Subsequently, withdraw the unit with both slides. (Fig. C).
Then remove the slides by pressing the springs on the right and left
sides of the unit.
If the unit was previously installed in another vehicle, it may be
necessary to adjust the springs on the unit before installation. To
adjust the springs, insert slide as shown in Fig. D and subsequently
adjust as shown in Fig. E (Gently press slide in the direction of 1
while at the same time moving the slide in the direction of 2).
Subject to correction and technical modifications
A
B
C
D
9
Installation guide
2
E
1
Copyright by Becker GmbH, D-76303 Karlsbad