Becker Traffic Pro Instructions De Montage page 18

Installation guide
Calibration setting:
Calibration settings should only be made when the val-
ues to be entered are known. The unit cannot perform
correct route calculations if incorrect values are en-
tered.
It is possible to provide calibration settings manually.
In the Service Mode, select
knob and press to confirm.
Using the right rotary knob
Using the right rotary knob
to confirm.
Unit rotation can be selected in degrees by turning the right rotary
knob and pressing to confirm.
Unit rotation corresponds to horizontal rotation. A positive
value means rotation of the front of the unit towards the
driver (LHD).
The unit inclination can now be selected in degrees by turning the right
rotary knob and pressing to confirm.
Unit inclination corresponds to vertical inclination. A posi-
tive value means upward inclination of the front of the unit.
Subject to correction and technical modifications
using the right rotary
CALIBRATION
select and press to confirm.
MODI.Y
select
CALIB RATION VALUES
18
GPS IN.O
C A L I B R A T I O N
CALIBRATION RIDE
DELETE
M O D I . Y
DO NOT DELETE
and press
MANU.ACTURE
C A L I B R A T I O N V A
BACK
HORIZONTAL UNIT TURNING
UNIT INCLINATION
Copyright by Becker GmbH, D-76303 Karlsbad
0
0