Initializing Gps And Performing The Sensor Test - Becker Traffic Pro Instructions De Montage

Installation guide

8. Initializing GPS and Performing the Sensor Test

• Connect the battery.
• Switch on the vehicle ignition to initialize the GPS and to perform
the sensor test. Switch on Traffic Pro.
Enter code (see the operation guide for a detailed description).
• Press the
1
button simultaneously.
• This calls up the menu for the initial GPS start-up and for the sen-
sor test.
• Drive the vehicle forwards or backwards at varying speeds to con-
firm operation of the speed signal test.
The number under
speed).
The number under
pressing the accelerator when the vehicle is parked.
• Engage the reverse gear for the reverse signal function test.
The arrows under
engaging the reverse gear.
• When initializing GPS, the vehicle must be parked outdoors, while
ensuring that it has a clear view in all directions (not in the imme-
diate vicinity of buildings).
Subject to correction and technical modifications
multifunction button and the
must change (even at a low
Speed
must not increase when idling or
Speed
must change direction on
Direction
R A D I O 9 9
multifunction
10
Bbc Ww1 Kbw Klc Usm Kbb _>
10
GPS WAIT
99.9
.: 1
ALM: 2
GPS WAIT
Speed Direction
.: 1
0 0 0
ALM: 2
GPS WAIT
Speed Direction
.: 1
0 1 2
ALM: 2
GPS WAIT
Speed Direction
.: 1
0 0 0
ALM: 2
Copyright by Becker GmbH, D-76303 Karlsbad
S: 1
S: 1
S: 1
S: 1