Skandika Fitness CARDIOBIKE THESEUS Instructions De Montage Et Mode D'emploi page 43

The function values:
The following values can be shown by the computer:
The computer shows the current speed in the display (max. 99,9 km/h).
SPEED
Computer shows actual exercise time (max. 99:59 Min).
TIME
Preset a target time:
You may preset a target time before starting a workout. The time will then count
down and multiple sound beeps will be emitted when reaching 0:00. How to preset
a target value, we have explained before.
The workout distance is displayed here (max. 99,99 km).
DISTANCE
Preset a target distance:
You may preset a target distance before starting a workout. The distance will then
count down and multiple sound beeps will be emitted when reaching 0,00. How
to preset a target value, we have explained before.
The currently burned calories are displayed here (max. 9999 kcal).
CALORIES (CAL)
Preset a target calorie consumption:
You may preset a target calorie consumption (kcal) before starting a workout. The
calories will then count down and multiple sound beeps will be emitted when re-
aching 0000 kcal. How to preset a target value, we have explained before.
The computer is showing the user's heart rate in beats per minute (min. 30 / max.
PULSE
240 beats per minute). For a correct display please ensure that you fully grasp
the hand sensors. It may last up to 2 minutes before the pulse frequency will be
measured correctly.
RPM
The computer shows the current rounds/min.
Further display
The computer shows room temperature, clock and date in Standby-mode.
Hints:
a) If the computer display does not show any values, please check all plug-in connections carefully to ensure that
they have proper contact, and look to see whether the batteries have been inserted correctly!
b) The calorie consumption values registered and displayed with this computer merely serve as indicative values
for a person of medium stature with medium resistance setting, and can deviate considerably from the actual me-
dically precise calorie consumption.
c) The pulse values registered and displayed with this computer are merely indicative in nature and can deviate
considerably from the actual pulse.
d) This computer has been tested according to the corresponding EMC standards. Even so, it is still possible for
interference, in particular electrostatic discharge, to affect the display, possibly resulting in an unwanted reset or
defect display. In this case, simply restart the computer (wait for it to switch off and on again) or take the batteries
out briefly).
COMPUTER | USE
43