Skandika Fitness CARDIOBIKE THESEUS Instructions De Montage Et Mode D'emploi page 42

COMPUTER | USE
You may now directly start to exercise, or you may preset target values for the functions TIME/DIS-
TANCE/CALORIES/PULSE. When you are in each set- up mode, for example in the time set-up mode,
time value is flashing, you can press "UP and DOWN" button to adjust the value and press "MODE" for
confirmation. The set-up of DISTANCE, CALORIES & PULSE is the same as for TIME. If you do not
want to preset value for a specific function, just set it to 0:00.
If you input several target values the computer will make a beep sound when you reach the first one of
these target values. In this moment you may stop exercise or continue to exercise. If you continue, the
computer will start to count up the value again.
During exercise, you may select the SCAN mode (press "MODE" until "SCAN" appears in the display).
In SCAN mode, RPM/SPEED/TM/DIST/CAL/PULSE will skip to display in every 6 seconds. You can
also press "Mode" button to select single function display except RPM & SPEED function. The RPM &
SPEED function will always switch display.
Independently from that, the function values will be displayed in the different areas on the bottom display:
Time
Distance
Calories
42
After that the computer is in normal training
mode and shows a display similar to this one.
Pulse
Speed