Skandika Fitness CARDIOBIKE THESEUS Instructions De Montage Et Mode D'emploi page 38

SET-UP
Step 4: Handlebars post and cables
Remove the pre-mounted handlebars post (C-1) by loosing the screws (C-4 / C-5). Connect both parts of
the tension cable (C-6 & D-20) as shown in the small drawing. If present, remove the safety clip before.
Now connect the computer cable ends (C-3 & D-2) accordingly between main frame and handlebars post
(C-1). Put the handlebars post (C-1) into the main frame [be careful not to squeeze any cables!] and fix
it with 4 screws M8x16 (C-5) 4 curved washers (C-4) as shown.
Hint: If the connection between the tension cable ends (C-6 & D-20) is difficult, try to manipulate the ten-
sion controller (C-6) located on the handlebar post in that way, that the upper tension cable comes out of
the lower end of the post as far as possible. This makes it easier to connect the cable to the respective
bottom part.
38