• mount The Probe onto the top of
the tank's sanitary ferrule
• secure mating by surrounding
the joint with the clamp
• tighten adjusting wing nut
Inside of sanitary
Note:
ferrule must be smooth, free of
burrs, seams or ridges.
Interconnection
Cable Entry
A. With lid closed, remove cable entry 'knock out' on either side as required.
B. Open lid by loosening the lid screw.
C. Run cable to The Probe.
D. Connect loop wiring.
E. Close lid. Tighten screw to 1.1 to 1.7 N-m (10 to 15 in-lb) of torque
System Diagram
The Probe
7ML19985GC62
*supplied with the Probe
instrumentation
The Probe – INSTRUCTION MANUAL
Sanitary Ferrule,4" FDA Approved
The Probe
(US Food and Drug Administration)
clamp*
adjusting
wing nut
ferrule
tank
dimensions
are approximate
loop
119 mm (4.68")
97 mm (3.83")
Page 3