Install Glass Sweep And Weather Stripping - Petsafe Freedom Manuel D'installation

Step 5

Install Glass Sweep and Weather Stripping

5A The glass sweep should be
installed on the back edge of the
sliding glass door to form a seal
between the sliding glass door
and the stationary glass door. The
weather stripping should be installed
on the front edge of the sliding glass
door to form a seal between the Patio
Panel and the sliding glass door.
Apply glass sweep and weather stripping to a clean dry surface at temperatures
above 63°F (17°C).
5B Close the sliding glass door against the Patio Panel. Clean and dry the
back edge of the sliding glass door. Position the glass sweep at the top glass
edge with the flexible part touching the glass of the stationary door.
Carefully peel away the backing and press the glass sweep in place as you
move down to the bottom of the glass. Trim any excess with scissors.
5C Open the sliding glass door. Clean and dry
the front edge of the sliding glass door. Position
the weather stripping at the top front edge
toward the interior side. Carefully peel away
the backing and press the weather stripping
into place as you move down to the bottom of
the door. Trim any excess with scissors.
10
5A
5C
www.petsafe.net
Sliding glass door shown here
slightly open
Sliding Glass Pet Door
Install glass sweep here
Install weather stripping here
5B