Installing Your Freedom ® Patio Panel; Measure - Petsafe Freedom Manuel D'installation

Height Adjuster: A metal panel with springs located above the top door section to adjust Patio
Panel height.
Sliding Glass Door Frame Opening: Opening in sliding glass door between the upper door track
and the lower door track.
Exposed Sliding Glass Frame: Sliding glass door frame that is visible and exposed in interior and
exterior wall.
Recessed Sliding Glass Frame: Sliding glass door frame that is flush with or barely visible in interior
or exterior wall.
Rise: The height from the floor to the bottom of the flap in the pet door. It is the height the pet must step
over to enter or exit the pet door.
Patio Panel Rib Line: Raised ribbed lines on left and right side of Patio Panel frame to indicate drilling
outside of rib line area. Do not drill inside of the rib line as glass is present and will break if drilling occurs
in this area.
Operating Temperature Range: 0º F to 100º F (-18º C to 38º C)
Installing Your Freedom
Prior to installation and drilling, consult your sliding glass door manufacturer's
warranty. Unauthorized changes or modifications may void the warranty. Installing
screws into vinyl door frames or door jambs may crack the vinyl.
Step 1

Measure

1A
Patio Panel
®
1A Prior to any Freedom Patio Panel Pet Door purchase, you must
determine the height of your sliding glass door frame opening.
Measure from highest point in upper door track to lowest point in
lower door track.
www.petsafe.net
5