Install And Attach Interior; Optional Support Installation - Petsafe Pet Door PPA11-10915 Manuel D'installation

Step 5

Install and Attach Interior

Optional Support Installation:

Optional:
5A. Measure from the inside of outer wall to the
inside of inner wall as shown. Cut a 2X4 to the measured
length, making sure that the cut is square. Remove any debris
that may be inside the wall where the support will be located.
Optional:
5B. Place support inside wall so that the top of
support is flush with the bottom of cut-outs. Use 2 drywall
screws (supplied) or 2 wood screws (optional) to fasten the
inner side of support as shown. Check again to make sure
that the support is flush with bottom of cut-outs.
Optional:
5C. Use the 2 drywall screws (supplied) or 2 wood
screws (optional) to fasten the outer portion of the support.
5D. Using the holes left by the drywall screws on the A side of pet
door as pilot holes, drill a ½" (13 mm) hole for the toggle bolts.
5E. Install the Toggle Bolts into the A side of the Pet Door as shown.
5F. Place the A side of the pet door back into the cut hole and
tighten the bolts. Be careful not to overtighten.
Helpful Tip: You may need to start the toggle bolt into the hole.
Be careful not to overtighten. Sometimes you need to hold the
screw out so the toggle is locked while you tighten the
screw until the toggle is tight enough that it will hold
itself in place while you finish tightening.
8
Make sure the support fits snug and that it is
not too long or too short. In either instance,
damage to the wall can occur.
If placing screws into vinyl siding it may be
necessary to drill a hole through the siding
slightly larger than the heads of the screws.
This will allow the screws to tighten flush with
plywood and not buckle the vinyl siding.
1-800-732-2677
5A
Optional
5C
Optional
5D
5E
5F
5B
Optional