aquatermic XK79 Manuel D'utilisation page 16

Wired Controller XK79
Fig. 3.14 is the simple installation process of wired controller; please pay attention
to the following items:
(1) Before installation, please cut off the power for indoor unit.
(2) Pull out the 2-core twisted pair line connected with the indoor unit from the
mounting hole and through the outer shell .
(3) Set the wired controller soleplate on the wall and use the M4X25 screws to fix
it with the mounting hole.
(4) separately fix the twisted pair on the H1 and H2 terminal by screws.
(5) Gate-control wiring notice:
1) If the gate-control system is not involved, open the inner shell and turn the No.1
switch of the DIP switch S1 to the number side which is located at the PCB of
the inner shell.
2) If the gate-control system is connected, make sure the No.1 switch of the DIP
switch S1 is turned to the "ON" side. Connect the gate-control terminal to the
N and L port or the VCC and GND port. Attention to the following items:
Fig. 3.14 Installation diagram for wired controller
12