Install Control Panel; Install Hardware; Install Bins / Shelves; Install Doors - Norcold 2118 Mode D'emploi

Assemble, cont'd.

Install Control Panel

4.6 4.6
1. Connect wire harness connectors to back side of control panel.
2. Put panel (Fig.6,B) in place, replace with original screw.
3. Connect water line to water dispenser (if present).
Note:
If model does not have a water dispenser, reinstall
dummy plate with original screw.
4. Connect in line electrical connector to water dispenser.
5. Put water dispenser or dummy plate in place; replace with original
screw.

Install Hardware

4.7 4.7
Caution!
To avoid equipment malfunction replace strike-
!
plate shims in exact location marked during removal.
1. With shims in original positions, reinstall top and bottom of strike-
plate assembly with original screws (4x).
2. Hold the upper-middle layer of the strikeplate in place and push
the lower-middle layer of the strikeplate in until it "snaps" into posi-
tion.

Install Bins / Shelves

4.8 4.8
1. Install the fresh food bottom shelf using the original screws and
spacers (2x) (Fig.2,E).
2. Put the freezer shelves (Fig.2,C) back into position and reinstall
the retainers above one end of the shelves.
3. Push crispers (Fig.2,F) and beverage bin back into positions.
4. If present, put ice bin back into position under ice maker.
Note:
Replacing bottom trim screws before top ones will
ease procedure.
5. Replace original screws (8x) in bottom trim bracket and then top
trim bracket.
6. Push top and bottom decorative trim pieces into position.(Fig.2,G).
7. From rear access panel, replace original anchor screws (Fig.1,B).
8. If you removed bottom drawer during disassembly, replace it now.

Install Doors

4.9 4.9
1. Place bottom hinge pin of door into hole in lower hinge bracket.
2. Rotate top of door up into position, replace top hinge pin. Tighten
pin in place.
3. Repeat for all doors (4x).
4. Line up hinge covers over middle hinge brackets, snap into posi-
tion.

Restore Power

5 5

Connect Propane

5.1 5.1
Danger!!!
Fire and explosion hazard. To avoid damage
!
to fi ttings and a dangerous propane leak that could
lead to death or destruction of property, always use two
wrenches to loosen and tighten the propane fi ttings. Do
not overtighten!
1. Install RV propane supply line (Fig.1,D), tighten. Do not over-
tighten!
2. Leave electrical power to refrigerator disconnected, open pro-
pane tank valve.
Danger!!!
Fire and explosion hazard. To avoid fi res or ex-
!
plosions that can cause death or destruction of property, never
use fl ames to check for propane leaks. Use an approved soap
solution that does not contain ammonia.
Danger!!!
Fire and explosion hazard. If bubbles form in
!
the soap solution, below, tighten the fi ttings or repair the fl ares.
DO NOT reconnect the electrical power until the connection
is free of leaks. A fi re or explosion resulting in serious injury,
death, or destruction of property could result!
3. Leak check fittings on both sides of gas valve and at burner using
an approved, ammonia-free soap solution. If necessary repair
leaks. Remember that with the power disconnected, only the entry
point of the gas valve can only be tested. The exit point can only
be tested after the gas valve is energized passing gas through to
the burner.
12
www.norcold.com