Stops; Preliminary Checks; Safety During Installation; Important - BFT FABER BT Mode D'emploi

STOPS

The gate can be stopped by stops secured to the floor so that travel is defined from opening to closing�
STOPS

PRELIMINARY CHECKS

Remember that the drive is designed to make the gate/door easier to use and will not solve problems caused by defective or poorly performed
installation or lack of maintenance�
Check that:
- the gate's running track is horizontal and that the hinges are strong enough to take the weight of the gate: once released, the leaf should be
perfectly still and should not open or close;
- there is a slideway at the top of the leaf to avoid vertical or lateral oscillations during manoeuvres;
- leaf movement is even and there is no friction concentrated in any part of its travel;
- the existing structure has the necessary durability and stability requirements, specifically screws, bolts and rods that must be suitably secured;
- the leaf surface is free of protrusions and sharp edges, without signs of abnormal wear, rust, breaks or cracks in the frame elements;
- there are mechanical stops secured to the ground in opening and closing;
- the stated temperature range is compatible with the site in which the automated system is due to be installed;
- any thresholds in the passageway and greater than 5mm are visible, highlighted or well-formed�
If the frame and gate do not meet the stated specifications, do not install the drive: have the frame adjusted as necessary by qualified personnel�

Important:

- Eliminate the gate lock or any other manual lock device�
- This product cannot be installed on leaves that incorporate doors�
- The pair of photocells supplied in the kit must be installed and tested at the end of installation�
- Make sure there are safety gaps < 8 mm in the upper guides or apply rubber protections�

SAFETY DURING INSTALLATION

During installation, please:
- use appropriate tools as specified by these instructions�
- use personal protection equipment (protective goggles, gloves) suitable to the work you are carrying out�
- display work in progress signs and do not leave the site unattended�
- do not connect to the mains until assembly is completed�
- once the equipment is connected to the mains, only touch buttons and adjustment devices necessary to program the unit�
- work and repairs not specified in these instructions are not authorised�
STOPS
37
-
FABER BT - FABER L BT KIT