Control Panel Installation - BFT FABER BT Mode D'emploi

CONTROL PANEL INSTALLATION

DIMENSIONS
IP 55
2� Open the 5 holes shown by the arrows
using a pin remover�
WARNING:
PRESS (NOT TOO
HARD ON THE EDGE
AS SHOWN) to avoid
damaging the board
inside!!
5� Turn the control panel
upside down
TABLE OF CABLE OUTSIDE Ø
1-Photocell TX
1-Photocell RX
The table is only valid for the cable gland kit
supplied by the Company�
3� Open the control panel lid�
6� Drill the four holes shown�
1� Close the control panel lid�
1-Motor 1
230V mains
1-Motor 2
4� Insert and fix the cable glands�
7� Insert the Fisher dowels and fix with
the screws as shown in the figure�
Ø5
3,9
32
FABER BT - FABER L BT KIT
43
-