Warnings - BFT FABER BT Mode D'emploi

WARNING! Important safety instructions� Carefully read and comply with all the warnings and instructions
that come with the product as incorrect installation can cause injury to people and animals as well as
damage to property�
The warnings and instructions give important information regarding safety, installation, use and
maintenance� Keep hold of instructions so that you can attach them to the technical file and keep them
handy for future reference�
Declarations of conformity can be found at http://www�bft-automation�com/CE� Instructions for use
and assembly can be found in the download section�
This product has been designed and built solely for the purpose indicated herein� Uses other than those
indicated herein might cause damage to the product and create a hazard�
- The units making up the machine and its installation must meet the requirements of the following European
Directives, where applicable: 2004/108/EC, 2006/95/EC, 2006/42/EC, 305/2011 (CPR), 99/05/EC and later
amendments�
- The Manufacturer of this product (hereinafter referred to as the "Company") cannot be held liable for improper
use or any use other than that for which the product has been designed, as indicated herein, as well as for the
failure to apply Good Practice in the construction of entry systems (doors, gates, etc�) and for any deformation
that could occur during use�
- The Company is not responsible for the failure to apply Good Practice in the construction and maintenance
of the doors, gates to be motorized, or for any deformation that might occur during use�
- Do not install this product in explosive atmospheres: flammable gas or fumes are serious safety hazards�
- Installation must be carried out using safety devices and controls that meet standards EN 12978 and EN 12453�
- Apply all the safety devices (photocells, etc�) required to keep the area free of crushing, dragging and shearing
hazards� Bear in mind the standards and directives in force, Good Practice criteria, intended use, installation
environment, operating logic of the system and forces generated by the automated system�
- Apply all signs required by the current regulations to identify hazardous areas (residual risks)� All installations
must be visibly identified in compliance with the provisions of standard EN 13241-1�
- If the automated system is installed at a height of less than 2�5m or is accessible, the electrical and mechanical
parts must be suitably protected�
- Install any fixed controls in a position where they will not cause a hazard, away from moving parts� More
specifically, hold-to-run controls must be positioned within direct sight of the part being controlled and,
unless they are key operated, must be installed at a height of at least 1�5m and in a place where they cannot
be reached by the public�
- Only use original spare parts for any maintenance or repair work� The Company disclaims all responsibility
for the correct operation and safety of the automated system if parts from other manufacturers are used�
- Do not make any modifications to the automated system's components unless explicitly authorized by the
Company�
- Dispose of all packaging (plastic, cardboard, polystyrene, etc�) in compliance with the current legislation� Keep
nylon bags and polystyrene out of the reach of children�
Anything that is not explicitly provided for in the installation manual is not allowed� The operator's proper
operation can only be guaranteed if the instructions given herein are complied with� The Company shall not
be liable for damage caused by failure to comply with the instructions featured herein� While we will not alter
the product's essential features, the Company reserves the right, at any time, to make those changes deemed
necessary to improve the product from a technical, design or commercial point of view, and will not be required
to update this publication accordingly�
32
- FABER BT - FABER L BT KIT

WARNINGS