Discharge; Discharge Settings - Team Orion TWINSPEC advantage Manuel D'instructions

The charge will be interrupted when any one of these conditions is met:
 The automatic delta-peak cut-off system activates
 The charged capacity reaches the preset value (for NiMH/NiCd)
 The charger software has determined that the LiPo/LiFe battery is full or charged according to
the preset values.
At the end of the charge, the "BATTERY CHARGE
COMPLETE" message will appear.
Press the ENTER key to display the final charge data. By pressing the + and – keys you can display
various information about the charger and battery. Please refer to screen overview sheet for more
information.
Charge end data LiPo/LiFe
Press the ENTER key again to return to the main charge screen
Note : if you have adjusted a trickle charge current, the charger will trickle charge your NiMh/NiCd
battery. This charge will be interrupted after 20 minutes or when you return to the main charge screen.
16
The charger is equipped with a discharge function to discharge your batteries. This allows you for
example to check their actual performance. You can adjust different discharge rates and discharge
end voltages to fine-tune this function to your requirements. Make sure you use discharge settings
which are compatible with your batteries.
Note: make sure you are adjusting the settings for the correct channel you wish to use.
Follow this procedure to modify the discharge settings from the main screen, use the + or -
keys to select discharge mode from the main screen (indicated by "DISCHARGE").
Select and modify the settings by pressing the ENTER key to navigate between the parameters
followed by the + and – keys to change the value of the parameter. To exit the setup mode, you can
press the MENU key once or the ENTER key until you have navigated through all the parameters.
Warning! If you press the ENTER key too long, the discharge will start with the actual settings.
Team Orion Advantage Twin Spec www.teamorion.com

Discharge

Discharge settings

The charger will display the default settings for
the selected type of battery. Make sure you use
settings that are compatible with you battery.
17