Télécharger Imprimer la page

Team Orion VST2 Sport Manuel D'instructions

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

INSTRUCTION MANUAL AND WARNINGS • READ BEFORE USE!
Thank you for choosing this Team Orion VST2 Sport motor.
It features the latest developments in brushless motor tech-
nology.
WARNINGS
• This is not a toy; do not let children operate this motor
without the supervision of an adult.
• Do not leave the system powered when it is not supervised.
• Do not make the motor spin without a load, this can dam-
age the moving parts.
• Check the recommended gear ratios and input voltage for
your motor, failure to do so may result in damage to the
motor.
• Do not use extreme settings/gearing which can make the
motor overheat and become damaged.
FEATURES
• World Champion Technology
• Sensor Brushless Motor
• Fixed timing
• Machined aluminum motor can
• Highly efficient cooling
• High performance 2-pole rotor
• Simple and highly reliable design
• Developed by Oscar Jansen
INSTALLATION
• Attach the motor to chassis using screws with the proper
thread and length, if the screws are too long it could dam-
age the motor's winding and lead to permanent damage
• Solder the ESC wires to the motor, respecting the ABC
wires order. Do not overheat the solder tabs.
• Connect the sensor wire to the sensor port of the motor. .
• Make sure you use the proper gearing for your motor (see
the chart).
• When installing a new motor, it is recommended you reset
or lower your ESC's timing settings.
USE
• Make sure that all connections are ok before powering up
the system.
• Make sure that the motor temperature remains around
80°C / 180°F max.
If the motor overheats it will lose power and excessive
heat can also damage it.
SPARE PARTS
• ORI28310 VST2 Sport Endbell w/ Sensor and Ball Bearing
• ORI28311 VST2 Sport Rotor
• ORI28312 VST2 Sport Screws
• ORI28313 VST2 Sport Spacer
• ORI28314 Motor Wires with 4.0mm Gold Plug
• ORI28315 Front Ball Bearing
Copyright 2014 © Team Orion
• The sensor circuitry is very sensitive to water/humidity, if
you run in wet/humid conditions you must protect the mo-
tor from exposure to water.
MAINTENANCE
• Brushless motors do not require a lot of maintenance. You
can clean out the motor and oil the ball bearings from time
to time.
• To disassemble the motor, 1. remove the 3 screws on the
front of the motor, 2.pull out the back cover and 3. Remove
the rotor.
• Be careful not to lose the rotor spacers and re-install them
in same order.
TROUBLESHOOTING
• If the motor is cogging, remove the sensor wire and test
the motor in sensorless mode. If it works in sensorless
mode, the ESC, sensor wire or sensor module might be de-
fective. Sensor modules can be bought separately.
• If the motor is not spinning, check the ABC wire order, in
sensor mode the order must be respected.
• If the motor is overheating, check the timing settings and
gearing.
WARRANTY
Team Orion guarantees this product to be free from manu-
facturing and workmanship defects. The warranty does not
cover incorrect installation, components worn by use, or any
other problem resulting from incorrect use or handling of the
product. No liability will be accepted for any damage result-
ing from the use of this product. By the act of connecting and
operating this product, the user accepts all resulting liability.
• Is considered incorrect use:
• Failure to follow instructions.
• Improper use of the product (abusive use, out of spec,
etc.).
• Failure to adapt settings for proper function (improper con-
nections, wrong gearing, installation, setup, etc.).
• Overload, overheating (desoldering, melting, etc.).
• Running in inadequate conditions (damage or rust from
rain, humidity, etc.).
• Improper maintenance (presence of dirt, etc.).
• Disassembly, modification by the user (modifying original
connectors, wires, components, etc.).
• Mechanical damage due to external causes.
Usage
Voltage
TC (small track)
2S / 7.4V
TC (big track)
2S / 7.4V
1:12
1S / 3.7V
2wd off-road
2S / 7.4V
2wd Short Course
2S / 7.4V
4wd off-road
2S / 7.4V
www.facebook.com/teamorion
21.5T
17.5T
13.5T
3.5:1
4.0:1
6.0:1
10.5T
8.5T
7.5T
6.5:1
7.3:1
7.7:1
6.3:1
6.5:1
8.5:1
9.5:1
8.0:1
10.0:1
11.0:1
9.0:1
10.0:1
www.teamorion.com
6.5T
8.0:1
7.0:1
10.5:1
-
11.0:1

Publicité

loading

Sommaire des Matières pour Team Orion VST2 Sport

  • Page 1 INSTRUCTION MANUAL AND WARNINGS • READ BEFORE USE! Thank you for choosing this Team Orion VST2 Sport motor. • The sensor circuitry is very sensitive to water/humidity, if It features the latest developments in brushless motor tech- you run in wet/humid conditions you must protect the mo- nology.
  • Page 2 BEDIENUNGSANLEITUNG UND WARNUNGEN • VOR DEM GEBRAUCH LESEN Vielen Dank für den Kauf des Team Orion Vortex VST2 Sport wird. Wenn der Motor überhitzt, nimmt die Leistung ab. Ex- Motors. Die Erfahrungen aus unserem Off-Road Weltmeister- treme Hitze kann den Motor beschädigen.
  • Page 3 • Développé par Oscar Jansen GARANTIE Team Orion garanti que ce produit ne comporte pas de dé- INSTALLATION • Fixez le moteur au châssis à l’aide de vis compatibles avec fauts de fabrication. Cette garantie n’est pas valable lors le moteur.
  • Page 4 • モーターの温度は常に80℃以内であるようにしてくださ カテゴリー 21.5T 17.5T 13.5T 10.5T 8.5T 7.5T 6.5T カテゴリー スペアパーツ • ORI28310 VST2 Sport Endbell w/ Sensor and Ball Bearing TC (small track) 2S / 7.4V 3.5:1 4.0:1 6.0:1 6.5:1 7.3:1 7.7:1 8.0:1 • ORI28311 VST2 Sport Rotor TC (big track) 2S / 7.4V...