Electrical Connections - Airwell DLS VAV SYSTEM Manuel D'installation Et D'utilisation

‹ All system elements are for use only inside the building.
‹ If the power cable cord is damaged – replacement must be done by the
factory technician only.

Electrical Connections

General instructions:
Use the power line cord connected to the VAV control box and follow the local
electrical installation codes and regulations:
1. Expose the wires edges for connecting into the terminal block of the
air condition.
2. Connect the power cord 3 wires into the terminals at the indoor unit.
3. Conjunct the power cord cable to the main supply power line cable with
tie-wraps.
Warning! Do not extend the power cord or any other
cables in the system.
Select the proper electrical drawing per the air condition type.
The controller must be connected only per the electrical drawing of the
installed air condition unit.
Warnings!
‹ System must be installed per the instruction in this document.
‹ In case system elements will be used not according to the instruction
written in this document, warranty will be not valid.
‹ Unprofessional installation and/or damage to the system elements will
cancel any warranty.
‹ No field repair allowed to any system elements.
‹ System elements repair are not allowed.
‹ Repair done by unauthorized personal will cancel warranty.
‹ Line power operation of not standard and approved by the power company,
such as operation from generator or building that was not connected by
the power company will cancel warranty.
4