Infra Red Receiver Unit; Display Mounting On The Wall; Handheld Remote Control Location Consideration - Airwell DLS VAV SYSTEM Manuel D'installation Et D'utilisation

Infra Red Receiver unit.

Display Location Consideration
It is recommended to mount the display near the ceiling
were room temperature is normal.
Install the display to match room decoration.
The display should be mounted in sight line with the
handheld remote controller.
The display should be mounted no more then 7 meters
from the handheld remote controller.
Do not mount the display in location were sun light or
fluorescent, halogen or other artificial light exposed
direct to the display.
The display is connected to the damper motor via communication cable type
RJ11-4.

Display mounting on the wall.

Use electrical hand drill to drill one 6 mm hole in the wall for the plastic
anchor.
Open the back side of the display and mark the location of the hole.
Use the screw supplied to mount the display's back on the wall.
The RJ11-4 communication connects the display to the damper motor. The
cable is
6 meter long and is delivering the data from the display to the damper motor.
Be sure to connect well (till the end) the connector at the damper side.

handheld remote control Location Consideration

Be careful to mount the remote control holder in sight line to the display and
in no more then 7 meters between the holder and the display.
It is recommended to mount the holder on the wall only after operating the
damper and do a few tests with the remote control to be sure the location
selected is suitable for the infra red signals transmission between the remote
control and the display.
6