Required Tools; Safety Instruction; Warnings - Airwell DLS VAV SYSTEM Manuel D'installation Et D'utilisation

VAV SYSTEM - System Installation Instruction

Required tools

1. Screw driver.
2. Hand Drill.
3. 6 mm Drill bit.

Safety Instruction

‹ Pay attention to the warning symbols in the document.
‹ Verify that the Air condition unit to be controlled by the VAV system, is
installed and ready for operation.
‹ The installation of the system must be in accordance with the local
regulations and all applicable codes.
‹ It is the responsibility of the installing contractor to determine and comply
with all applicable codes and regulations.
‹ The installer must be an experienced service technician, trained in the
installation of this type of equipment.

Warnings

‹ To prevent electrical shock or equipment damage, disconnect power supply
before installing and maintaining the system.
‹ The installer must be an experienced service technician trained in the
installation of this type of equipment.
‹ Before start-up, read all safety instruction in this manual and become
familiar with the system and its operation.
‹ Unprofessional installation may create electrical short and operation
problems.
‹ Be sure to connect the VAC control box main power cord 230 VAC to the
230 VAC terminal connections at the air condition unit.
(Be careful when 3 Phase units are in use. Must connect between Phase
and Neutral).
‹ Use of power line or electrical socket which are not made for this kind
of installation, may create electrical short and fire. In any question or
clarification, please follow the instruction in this document.
‹ Do not use damaged power line cord, cable which is made from few cable
segments or if it's connected to an extension cable.
‹ Be careful to close the metal cover of the VAV controller.
‹ Don't install the system in an area where there may be gas leakage.
Attention
Do not install the system in laundry
room or bathroom, where condensation
may drip from the ceiling.
3
E n g L I S h