Cables Connection Between Damper Motors And Vav System Controller - Airwell DLS VAV SYSTEM Manuel D'installation Et D'utilisation

Cables Connection between damper motors and VAV
SYSTEM controller.
‹ The damper motor connects direct to the controller with RJ45 type cable,
3 meters long.
‹ Be careful to enter the plug into the socket at the motor side till the end, to
enable good electrical connection.
‹ It is NOT allowed to extend this cable.
Damper Size definition and use of channels #1 and #2.
Near to channel #1 and #2 connectors, you will find Dip Switches which allows
to select the size of the dampers and the number of dampers connected to
each channel.
Dip Sw. #1 selects the size of the damper 6", 8" or 10". (160mm, 200mm,
250mm)
Dip SW. #1 OFF = 6" or 8" Damper or 30 cm x 15 cm grill.
Dip SW. #1 ON = 10" Damper or 40 cm x 15 cm / 50cm X 15cm Grills.
Dip Sw. #2 defines if one or two dampers connected to the channel.
Dip SW. #2 OFF = One damper.
Dip SW. #2 ON = two dampers.
Dip SW. #2 ON not used with grills.
Channel #1 is factory set to damper size 10".
Dip Sw. #1 Dip Sw. #2 Dampers
ON ON
OFF ON
ON OFF
OFF OFF
2 Dampers size 10"
2 Dampers size 8"
One damper size 10" One Grill 40 cm
One damper size 8"
Grills
Not Applicble
Not Applicble
x
One Grill 30 cm x15
15 or 50cm 15cm
cm x
cm
E n g L I S h
7