Define Individual Id Code To Each Remote Control - Airwell DLS VAV SYSTEM Manuel D'installation Et D'utilisation

Rectangular Grill
1. The Infra Red receiver is located at the frame of
the grill.
2. The Indication light (Green Color) is located at the
frame of the grill.
Working Light (Green)
When this light is ON, it's indicating that the grill is in working mode.
When this light Blinking, it indicates transmission reception from the
handheld remote control.

Define individual ID code to each Remote control

The remote controllers supplied from the factory with default ID address of
"0". (Zero)
ID address of "0" allows operation with all 6 channels.
In situation where one remote control effects more then one room (cross
talk), it is possible to select individual ID address to each remote control.
In this case every remote will operate only to that specific room.
ID Address range from 00 to 07.
Channel No. 1 receives ID 01.
Channel No. 2 receives ID 02.
Channel No. 6 receives ID 06.
To select ID address, be sure that the remote control is ON.
Press at same time both on the ON/OFF and "+" buttons for continues
6 seconds.
On the display will appear the numbers "00". ("00" is the default address
operates all channels).
With the Up "+" and Down "-" buttons select the required ID address.
After reaching to the required ID address, press the DAMPER button to
enter the new ID into the memory.
After pressing the DAMPER button, the display will return to display the
temperature set point and the remote will return to normal operation.
To be sure that the new ID address was selected well, send a command
to the display and watch that the damper response to that command.
20
1
2