GYS ARTIC 4000 Mode D'emploi page 7

Translation of the original instructions
TROUBLESHOOTING
Troubleshooting
• Short-circuit.
1 • Open circuit.
• Polarity reversal
Unplug clamps or terminals during the
2
charge.
3 Battery voltage too high.
Battery is faulty or has a very low
4
voltage.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
ARTIC 4000
Causes
• Make sure that there is no power consumption (normal or abnormal) in
the vehicle circuit.
• Check that the clamps are properly connected.
• After following these steps, if the indicator still does not light up, the
sulfated/damaged battery must be replaced.
Reconnect the charger to the battery.
Check that the selected voltage matches the battery voltage (6, 12 or 24V).
Change the battery.
Solutions
EN
7