Service Notes - Revell Control Pulse FPV Mode D'emploi

10C Expert menu
Different settings can be made in the expert menu such as
• Control direction reversal (Set Reverse)
• Control sensitivity (Set Sensitivity)
• Video channel selection (5.8G frequency)
• Set manual (free flying mode) Important: The altitude sensor
is deactivated. Never activate this function as the thrust controller on
the remote control is always in the centre position, i.e. at medium speed.
• Fly when no GPS: Here you can deactivate the obligatory GPS and
fly indoors for example.
• Show Version (display of the software version). Normally it is not necessary to
make changes here. Therefore, we recommend reserving this menu exclusively
for Revell Customer Service and to refrain from making any changes. Menu
navigation takes place with control (2B) for up/down and left/right.
Activating the Expert menu:
• Hold the control for thrust (2A) all the way down
• Simultaneously press the control for forward/backwards (2B) down vertically
• for at least one second.
• To save the settings and exit the menu, press the control for forward/backwards
(2B) down vertically for at least 2 seconds
26
TROUBLESHOOTING
Problem: The propellers do not move.
Cause: 1. No connection has been established.
2. The battery is too weak or depleted.
3. Model cannot receive enough satellites.
Remedy: 1. Switch everything off and switch on again in the correct sequence.
2. Charge the battery.
3. Wait until the model has connected to at least six satellites.
Problem: The model stops and descends during flight for no apparent reason.
Cause: • The battery is too weak.
Remedy: • Charge the battery.
Problem: The model cannot be controlled with the transmitter.
Cause:
1. The ON/OFF switch is in the „OFF" position.
2. The batteries were not inserted correctly.
3. The batteries do not have enough power.
Remedy: 1. Set the ON/OFF switch to the „ON" position.
2. Check whether the batteries are inserted correctly.
3. Insert new batteries
Problem: The model only turns on its vertical axis or rolls over when started.
Cause: • Incorrect arrangement of the propellers.
Remedy: • Install the propellers and arms as outlined in the manual.
Additional tips and tricks can be found online at www.revell-control.de.

SERVICE NOTES

Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
27