Service Notes - Revell Control ORBIX Mode D'emploi

8 changing thE propEllErs
If the rotor blades on the model are damaged, they must be
replaced. To do so, proceed as follows:
8A Reach under the rotor with two fingers and carefully slide it
upwards and off.
8B Carefully press the new rotor blade vertically onto the shaft.
8C When mounting the rotor blade, please note that there are
clockwise rotating (A) and anti-clockwise rotating (B) rotor
blades.
Additional tips and tricks can be found online at
www.revell-control.de.
24
troublEshooting
Problem: The propellers do not move.
Cause: • No connection has been established.
• The battery is too weak or depleted.
Remedy: • Switch everything off and switch on again in the
correct sequence.
• Charge the battery.
Problem: The model stops and descends during flight for no
apparent reason.
Cause: • The battery is too weak.
Remedy: • Charge the battery.
Problem: The model cannot be controlled with the remote
control.
Cause: • The ON/OFF switch is in the „OFF" position.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Set the ON/OFF switch to the „ON" position.
• Check whether the batteries are inserted correctly.
• Insert new batteries
Problem: The model only turns on its vertical axis or rolls
over when started.
Cause: • Incorrect arrangement of the propellers.
Remedy: • Install the propellers and arms as outlined in the
manual.
Problem: The model will no longer fly loops.
Cause: • Battery too weak.
Remedy: • Charge the battery.

sErvicE notEs

Go to www.revell-control.de for ordering
information and tips on replacing spare
parts, plus other useful information on all
Revell Control models.
www.revell-control.de
25