Service Notes - Revell Control HEXATRON Mode D'emploi

8 ChaNgINg The propellerS
If the rotor blades of the multicopter are damaged, they must be replaced.
Proceed as follows:
8A Prior to installation, make sure that you do not mix up the propellers.
The multicopter has 4 different propellers, which differ in colour and direction
of rotation. If the propellers are mixed up, the multicopter will not fly. The two
blue propellers are in front.
8B Unscrew the securing screw of the propeller anti-clockwise from the hub of the
propeller and carefully remove the defective propeller from the shaft.
8C Carefully fit the new propeller on the shaft and carefully screw the securing screw
on again in a clockwise motion.
8D Figure 8D shows a top view of the multicopter. The propellers are marked with a
small 1 or 2 on the underside in the centre. Please assemble as follows:
Black 2 centre left Blue 1 front left
Black 1 centre right Black 2 right rear
Flight direction
The rear side of the multicopter is where the battery cable was soldered to the
printed circuit board.
TroUBleShooTINg
Problem: The propellers do not move.
Cause: • The ON/OFF switch is in the "OFF" position.
• The battery is too weak or depleted.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Charge the battery.
Problem: The multicopter stops and descends during flight for no
apparent reason..
Cause: • The battery is too weak.
Remedy: • Charge the battery.
Problem: It isn't possible to control the multicopter using the
remote control.
Cause: • The ON/OFF switch is in the "OFF" position.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Set the ON/OFF switch to the "ON" position.
• Check whether the batteries are inserted correctly.
• Insert new batteries.
Problem: The multicopter only turns on its vertical axis or rolls over
when started.
Cause: • Incorrect arrangement of the propellers.
Remedy: • Install the propellers as outlined in the manual.
Problem: The multicopter won't fly a looping manoeuvre.
Cause: • The 3-stage switch is not set to 100%, battery too weak.
Remedy: • Press the 3-stage switch all the way to the right, charge the battery.
20 20
Blue 2 front right
Black 1 rear left
Additional tips and tricks can be found online at www.revell-control.de.

SerVICe NoTeS

Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
21