Operation; Care - Broan EW48 Serie Manuel D'installation, D'utilisation Et D'entretien

13. OPERATION

Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the
air after you turn off the range. This will help keep the whole kitchen cleaner and brighter.
1. B ON/S
LOWER PEED INCREASE KEY
Press the Blower ON/Speed increase push button to activate the blower at low speed. Press twice for medium speed and once more for
high speed. The LED indicator below the key will light according to the speed level chosen (one LED = low speed, 2 LEDs = medium
speed, 3 LEDs = high speed). Press once more to turn OFF the blower; the LED indicators will then shut off.
2. M ON/OFF
ASTER KEY
When blower and light are ON, press the Master ON/OFF to turn OFF both blower and light. When blower and light are OFF, press this
key to turn ON the blower to the previous speed setting and turn ON the light at the previous light intensity.
3. L + OFF
IGHT INTENSITIES
Press this key once to turn ON the light on low intensity, one LED indicator will light. Press once more to turn the light on high intensity
(both LED indicators will light). Press another time to turn OFF the light (both LED indicators will then shut off).

14. CARE

Grease Filter(s)
Grease filter(s) should be cleaned frequently. Use a warm dishwashing detergent solution to clean the filter(s). Grease filter(s) are
dishwasher safe.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate
detergents, or as a result of local water conditions - but this will not affect filter performance. This discoloration is not covered by the
warranty. To minimize or prevent discoloration, hand wash filters using a mild detergent.
Non-ducted Filters
Change the non-duct recirculation filters every 6 months. Purchase S99010473 for 24-in and 30-in range hoods or S99010474 for 36-in
range hoods.
Hood Cleaning
Stainless Steel Cleaning:
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
Painted finish cleaning:
Clean with warm water and mild detergent only. If discoloration occurs, use a finish polish such as automotive polish. (DO NOT use rough
abrasive cleaner or porcelain cleaner.)
1
HC0088
1) Blower Speed key + OFF
(D
OUBLE FUNCTION KEY
:
KEY
2
2) Master ON/OFF key 3) Light Intensities + OFF key
):
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
10
3