Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
PM400SSV
NOTES: 1. Each time a key is pressed, a beep is emitted to acknowledge the command. To disable, when the fan and
2. Each time a key is pressed, its backlight turns ON. When a function is turned OFF, so does the corresponding
Master ON/OFF:
Press this key to turn on the light and the fan at the last
saved intensity. The backlights of the master ON/OFF
button, fan button and light button are turned ON. When
either light and fan are ON, pressing on this key will
memorize the current fan speed and lighting level prior
to shut them OFF.
Whenever there is an active function (light or fan is
turned ON directly by pressing the fan or light key),
the master ON/OFF backlight is turned ON. When the
last active function is turned OFF (light or fan is turned
OFF directly by pressing the fan or light key), the master
ON/OFF backlight is also turned OFF.
Fan:
When fan is OFF, a key press turns ON the fan to the
last saved speed. If there was no speed saved, the fan
will be set on LOW speed. To change the fan speed,
press the key again until the desired speed is reached
(from LOW, to MEDIUM to HIGH speed to OFF).
When the fan is ON (no matter the speed level), a long
key press turns the fan OFF and the current fan speed
setting is saved to memory.
Filter Cleaning Reminder
When the user turns the fan OFF, and the fan key
backlight flashes slowly during 30 seconds, then this
means it is time to clean the hood and filter. Refer to the
Maintenance and Cleaning Section on page 22. This will
happen every time the user turns the fan OFF (and the
timer has not been reset).
Once the cleaning is done, at any time during the
30-second signal (and the fan is OFF), a long press of
the fan key will reset the timer and stop the key backlight
flashing.
16
lights are OFF, press on the Lights key (
press again on the Lights key (
key backlight.
) for 5 seconds. To put it back, when the fan and lights are OFF,
) for 5 seconds.
Lights:
Press this key to turn ON the lights to the last saved
intensity. If there was no light intensity saved, the lights
will be set on LOW intensity. Press another time to set
the lights to HIGH intensity. Pressing another time after
the HIGH intensity will turn OFF the light.
When the lights are ON, a long press turns the lights
OFF and the current light intensity is saved to memory.
The next time the lights are turned ON (either with the
light key or the master ON/OFF key), it does so at the
last saved intensity.
Delay OFF:
When fan is ON, press this key to activate the delay
function; the delay off key backlight will be ON for the
duration of the delay (or until cancelled). The fan will
continue to operate for 10 minutes and then, will shut
off automatically.
When the delay mode is active, it is possible to change
the fan speed by pressing the fan key without affecting
the remaining time of the delay.
To cancel the delay function before the end of the
10 minute-cycle, press again on the delay OFF key or
on the Master ON/OFF key.
Wi-Fi/Bluetooth
Go to page 18.
:
®
Publicité
Table des Matières
