Operation; Connecting To Mains / Disconnecting - Wella Professionals VISIONAIR Mode D'emploi

4

Operation

Figure 1

4.1 Connecting to mains / Disconnecting

The socket outlet with earthing contact must have at least 10 ampere protection.
We recommend that the wiring in your salon is protected with a residual current
circuit breaker (RCCB) (Release current maximum 30 mA) fitted by your
electrician.
4.1.1 Checking power supply voltage
Power supply voltage rating
• The power supply voltage of the appliance can be found on the type
plate 1 on the underside of the appliance.
1. Check that the mains voltage corresponds to the information on the type plate
1.
• If in doubt, contact your electricity supply company or a local qualified
electrician or electrical contractor.
4.1.2 Connecting to mains
1. Check the power plug e and mains cable d for damage.
2. Use the recessed handles 8 to move the appliance to or position it in the
place where treatment is to be performed.
3. Insert the power plug e of pedestal version into a socket.
Electric shock
• In the event of an electrical short circuit, earthing reduces the risk
of an electric shock.
• The wall-mounted version (protection classI) should only be used
with a properly earthed socket outlet with earthing contact.
4. Insert the power plug e of wall-mounted version into a properly earthed
socket outlet with earthing contact.
5. Arrange the mains cable d of pedestal version so no-one can trip over it.
4.1.3 Disconnecting from mains
To avoid damage to the appliance:
• Do not pull on the mains cable d.
• Do not squash or kink the mains cable d.
1. Switch off appliance at the ON/OFF switch a.
2. Disconnect from mains by gripping and pulling out the power plug e.
3. Wind the mains cable d around the cable hook c (only pedestal version) to
avoid tripping and falling.
NOTE
1
WARNING
39