Operating And Display Elements - Conrad 75 11 71 Notice D'emploi

7. Operating and display elements

The illustrations are located on the fold-out page.
A LED standby
If the device is on, this LED is green.
B LED „CH1"
Is lit as soon as video channel 1 is displayed on the monitor.
C „CH1" key
Press the „CH1" key to show video input 1 on your display.
D Control cross
The control cross serves to control (swivel and tilt) the cameras connected.
E POWER switch
You use this switch to switch the device on and off.
F „CH2" LED
Is lit when video channel 2 is currently displayed on the monitor.
G „PAN" LED
Lights up as long as the automatic swivel function is activated.
H „PAN" key
By pressing this key the automatic swivel function is activated.
I „CH2" key
Press the „CH2" key to show video input 2 on your display.
J IR receiver
Receives the signals of the supplied remote control.
K SCART connection
For connection to a TV set
L „POWER IN" low voltage socket
For connection to the supplied external power socket plug.
M „CH 1" connection socket
For connection of external video signal sources (e.g. surveillance cameras) with analogue video out-
put.
N „CH 2" connection socket
For connection of external video signal sources (e.g. surveillance cameras) with analogue video out-
put.
22