Handling - Conrad 75 11 71 Notice D'emploi

10. Handling

Observe all safety instructions in these operating instructions!
You may only operate the control unit in dry indoor areas. Contact with moisture
must be avoided at all times. Never touch the device and its plug-in power supply
when your hands are wet or damp. There is a risk of a fatal electric shock.
• Avoid the following unfavourable ambient conditions at the installation point or during transportation
of the control unit:
- wetness or excess air humidity
- extreme cold or heat
- direct sunlight
- Dust or combustible gases, vapours or solvents
- Strong vibrations
• Avoid the following unfavourable ambient conditions at the installation point or during transportation
of the camera:
- Direct rain
- Standing water
- extreme cold or heat
- direct sunlight
- Dust or combustible gases, vapours or solvents
- Strong vibrations
• When the camera or the control unit is brought from a cold into a warm room condensation may form.
Let the camera, the control unit and the plug-in power supply get to room temperature first, before the
devices are used or before connecting them with mains voltage. This process may take several
hours.
Otherwise the digital timer may get damage, there is furthermore the risk of a mortal electric shock.
• When installing the devices, make sure that no cables are pinched or caught.
• Before connecting or disconnecting cables/devices, the control unit has to be switched off.
• Always check the devices for damage every time before using them. If you notice any damage, the
plug-in power supply must not be connected with the mains voltage and the control unit must not be
used.
Safe operation must be presumed to be no longer possible, if
- the device is visibly damaged,
- the device is no longer functional and
- the unit was stored under unfavourable conditions for a long period of time or
- if it has been subjected to considerable stress in transit.
26